Home theater speaker setupSpeaker's side binding posts Some higher-end speakers also ship with two set of posts to facilitate bi-amplification and wiring for enhanced performance (theoretically speaking, of course). These are factory wired with metal "jumpers" that bridge both sets of red and black posts for conventional mono-amplification setup. Hooking up the speaker cable to any of the posts in the same group is fine, provided firm contacts are established between the two. |
- Talkback
-
lv208306 says...
I am using copper monster cables with 4 small cables in each main cable for my speakers. However, I have difficulty in inserting the 2 cables that go into each of the binding post because the hole on the latter is too small.
As such, can you advise me as what I should do? Thanks
Jan 04, 2008 14:26
I am using copper monster cables with 4 small cables in each main cable for my speakers. However, I have difficulty in inserting the 2 cables that go into each of the binding post because the hole on the latter is too small.
As such, can you advise me as what I should do? Thanks
Jan 04, 2008 14:26
Glifford says...
Dear LV208306,
Maybe you can try using pin plugs shown in the last slide of the article.
Sep 17, 2008 17:59
Dear LV208306,
Maybe you can try using pin plugs shown in the last slide of the article.
Sep 17, 2008 17:59
To post comments, you need to become a member. It's FREE.
